![]() Some common features to consider are Material and Type. I know some people have good results with a punch as well.but the "I broke xxx." stories are the ones that concern me. Crazy Crow Trading Post: Largest line of craft supplies & kits for Native Americans & Historical Reenactors anywhere. While these are popular, we recommend ensuring that the Rivets you consider have the right mix of features and value. Sure, you could do these methods, but I believe the whole point of the press is to apply gentle even pressure to cleanly and evenly install tubular rivet with reduced risk of cracking, breaking pieces, or having loose rivet.Ĭonsidering the cost or rarity of a lot of ramps etc, I personally would opt for a press option if possible. You could probably make something similar out of a $3 C clamp if you've got the patience to grind/dremel both sides. These precision-molded industrial strength polyoxymethylene (POM) rivets securely lock components in place and prevent pull outs. ![]() I typically use an AR stake swivel rivet tool.looks similar to this, but didn't cost me $50 (think it was about $15 years ago): (Put the face of the rivet into the anvil, carefully flare the back with a punch. For simple brass/aluminum/other soft rivets you'll find in pins, There are cheap tools on Amazon and eBay for leatherworking that should work reasonably well: ![]() You can use a rivet punch and something to back it and do a reasonable enough job.no need for an arbor press. ![]()
0 Comments
Leave a Reply. |